Commit 262b8211 authored by Reinhold Kainhofer's avatar Reinhold Kainhofer
Browse files

Adjust the config for our GasSensor configuration

parent 4f46e9fd
......@@ -5,7 +5,7 @@
* Sketch configuration
*/
#define SKETCH_NAME "NodeManager"
#define SKETCH_NAME "MH-Z19"
#define SKETCH_VERSION "1.0"
/**********************************
......@@ -113,26 +113,26 @@
#define DEBUG 1
// if enabled, enable the capability to power on sensors with the arduino's pins to save battery while sleeping
#define POWER_MANAGER 1
#define POWER_MANAGER 0
// if enabled, will load the battery manager library to allow the battery level to be reported automatically or on demand
#define BATTERY_MANAGER 1
#define BATTERY_MANAGER 0
// if enabled, allow modifying the configuration remotely by interacting with the configuration child id
#define REMOTE_CONFIGURATION 1
// if enabled, persist the remote configuration settings on EEPROM
#define PERSIST 0
// if enabled, a battery sensor will be created at BATTERY_CHILD_ID (201 by default) and will report vcc voltage together with the battery level percentage
#define BATTERY_SENSOR 1
#define BATTERY_SENSOR 0
// if enabled, a signal sensor will be created at RSSI_CHILD_ID (202 by default) and will report the signal quality of the transport layer
#define SIGNAL_SENSOR 0
#define SIGNAL_SENSOR 1
// if enabled, send a SLEEPING and AWAKE service messages just before entering and just after leaving a sleep cycle and STARTED when starting/rebooting
#define SERVICE_MESSAGES 0
// Enable this module to use one of the following sensors: SENSOR_ANALOG_INPUT, SENSOR_LDR, SENSOR_THERMISTOR, SENSOR_ML8511, SENSOR_ACS712, SENSOR_RAIN, SENSOR_SOIL_MOISTURE
#define MODULE_ANALOG_INPUT 1
#define MODULE_ANALOG_INPUT 0
// Enable this module to use one of the following sensors: SENSOR_DIGITAL_INPUT
#define MODULE_DIGITAL_INPUT 1
#define MODULE_DIGITAL_INPUT 0
// Enable this module to use one of the following sensors: SENSOR_DIGITAL_OUTPUT, SENSOR_RELAY, SENSOR_LATCHING_RELAY
#define MODULE_DIGITAL_OUTPUT 1
#define MODULE_DIGITAL_OUTPUT 0
// Enable this module to use one of the following sensors: SENSOR_DHT11, SENSOR_DHT22
#define MODULE_DHT 0
// Enable this module to use one of the following sensors: SENSOR_SHT21, SENSOR_HTU21D
......@@ -156,9 +156,9 @@
// Enable this module to use one of the following sensors: SENSOR_MCP9808
#define MODULE_MCP9808 0
// Enable this module to use one of the following sensors: SENSOR_MQ
#define MODULE_MQ 0
#define MODULE_MQ 1
// Enable this module to use one of the following sensors: SENSOR_MHZ19
#define MODULE_MHZ19 0
#define MODULE_MHZ19 1
// Enable this module to use one of the following sensors: SENSOR_AM2320
#define MODULE_AM2320 0
// Enable this module to use one of the following sensors: SENSOR_TSL2561
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment